minimum load

英 [ˈmɪnɪməm ləʊd] 美 [ˈmɪnɪməm loʊd]

网络  最小负载; 最小负荷; 最小负载电流; 最小载荷; 最低佣金

化学



双语例句

  1. The Application of Minimum Load in the Control of the Electronic Belt Weigher
    最小负荷在电子皮带秤控制中的应用
  2. The concrete slabs strengthen the torsion buckling capacity of the steel grids and enhance the minimum geometric nonlinear buckling load.
    混凝土面板加强了网架的抗扭转屈曲能力,提高了最小几何非线性屈曲荷载。
  3. A forecast may be made with maximum or with minimum load growth rate.
    负荷的预测可以用最大或最小负荷增长率来进行。
  4. Basing on the analysis of deformation and stiffness of the transmission system, 3-D correcting quantity is accounted according to the3-D correcting surface and minimum principia of load density.
    在分析传动系统变形和支承结构刚度的基础上,根据三维修形曲面以及误差、载荷密度最小化原则计算确定齿轮修形量。
  5. No load to minimum load power limitation, adaptive ability of lamps and lanterns stronger, more cost-effective.
    无负载最小负载功率限制,对灯具的适应能力更强,成本更低。
  6. The data showed that the maximum load was on the plowshares spade, and the minimum load was in the area of the transition from plowshare to the wall.
    测试结果表明,该测试手段满足使用要求,其数据表明最大点荷载产生于犁铧的铧面上,最小点荷载产生在犁铧与犁壁的过渡区域。
  7. The pilot study of the regulation of peri-implant crestal bone loss during unloaded period; Base load [ electricity]: The minimum load over a given period of time.
    非负荷期种植体周围骨吸收规律的研究基底负荷[电力]:在一定时期内的最小负荷。
  8. The analysis of the effect on pinned connection for the column of boiler steel structure is given here by use of linear elastic stability theory The minimum load carrying capacity required for fixed connection is presented.
    用小变形弹性稳定理论分析铰接连接对钢架柱稳定的影响,并提出满足柱刚接条件的最小节点承载要求。
  9. The minimum value of all load bus index values can be looked as the voltage stability index of the whole power system. Correspondingly, the load bus with minimum value of the index is the weakest load bus.
    将系统中所有负荷母线的最小指标值作为该系统的电压稳定指标,该最小值所对应的母线为系统中的最薄弱母线。
  10. The result of computerization of the rod string dynamic parameters indicates that the maximum polished rod load in slant straight wells changes not obviously and the minimum polished rod load decreases prominently in comparison with that in verticle wells.
    利用微机对斜直井抽油杆柱动态参数的预测计算结果表明,与竖直井相比,斜直井最大光杆载荷变化不大,最小光杆载荷减小很多。
  11. This article gives the suggestions of optimized design, and the comparisons of rational unburnt coal loss and minimum stable combustion load rate between W? flame boiler and conventional combustion modes.
    文中给出了优化设计的推荐意见和其合理的未燃碳损失及最低稳燃负荷率与常规燃烧方式的比较。
  12. The limit minimum load of the vertical soil pressure is called relaxation soil pressure.
    垂直土压力的极限最小荷载称为松动土压力,当管片提供的反作用力大于此荷载时,隧道上部土体能够保持稳定。
  13. An improved reliability evaluation model is presented to simplify each secondary sub-network by a multi-state equivalent generator model and an equivalent load model, and modify the linear planning model of minimum load curtailments at the same time.
    提出了一种改进的可靠性模型,用具有多状态的等值发电机和等值负荷来简化二次电网,并对最小切负荷量的线性规划模型进行修正。
  14. This paper presents the testing of wire rope in the reinforced flexible flat cable for minimum tensile load and suggestions for selection of the wire rope.
    本文提出了加强型扁软电缆用钢丝绳最小拉断力的简易检测方案及选配建议。
  15. The minimum measurement mileage of load spectrum was determined on the basis of largest ex-treme value distribution theory and analysis technique, which were presented by forerunners.
    根据前人建立的极值分布理论和分析技术确定了EQ140后桥在不同道路上垂直载荷谱的最短测量里程。
  16. The Allowance Minimum Load Impedance of Microcomputer-based Protection Type WXB-11
    WXB-11型微机保护允许最小负荷阻抗的探讨
  17. Optimal Design for Pick Arrangement Parameters on Cutting Head of Roadheader Based on Minimum Load fluctuation
    基于载荷波动最小的掘进机截割头截齿排列参数优化设计
  18. Five-grade failure tree is generated based on fault analysis algorithm of minimum load increment with the APDL ( Ansys Parametric Design Language) in data processing.
    以最小荷载增量准则为失效分析理论,利用Ansys的APDL参数化设计语言进行后处理,生成大桥前五级失效历程的失效树。
  19. The Galerkin method has been employed in solving the equations and a minimum monolithic critical load has been obtained.
    用Galerkin法求解方程并获得整体结构的最小临界荷载。
  20. Analysis shows that the effect of construction of concrete slabs on the minimum geometric nonlinear buckling load coefficient λ is not significant.
    分析表明,混凝土面板施工对最小几何非线性屈曲荷载系数λ影响不明显。
  21. Taking the minimum control energy reentry trajectory with fixed terminal time and the minimum total heat load reentry trajectory as examples, some key problems such as parameterized method were discussed in detail.
    以终端时间固定的空间最小控制能量再入轨迹和终端时间自由的平面最小热载再入轨迹为例,详细讨论了遗传算法用于再入轨迹优化设计所需要解决的一些关键问题。
  22. It built the relationship among land top maximum load, minimum load, minimum tensile strength, serve coefficient and discharge coefficient etc, then got the method of calculating discharge curve in the polymer flooding and rod pump production.
    确立了悬点最大载荷、最小载荷、最小抗张强度、使用系数和排量系数等参数之间的关系;提出了聚合物驱有杆泵采油流出曲线计算方法。
  23. The effect of pinned connection on the column of boiler steel structure and the minimum load carrying capacity required for fixed connection
    铰接接头对锅炉钢架柱稳定的影响及刚接的最小承载要求
  24. By the analysis of pick arrangement parameters influenced on the load acting on cutting head, the strategy is presented to depress the load fluctuation. And the mathematic model of optimal design for pick arrangement parameters based on minimum load fluctuation is built.
    通过分析截齿排列参数对截割头载荷的影响,提出了降低载荷波动的策略,建立了基于载荷波动最小的截割头截齿排列参数优化设计数学模型。
  25. For the cell working range ascertainment, the algorithm determines the maximum output load, the minimum output load, the maximum input signal slope and the minimum input signal slope;
    通过计算单元在各测试状态下的最大、最小输出负载,输入信号的最大、最小斜率,算法能精确计算单元的工作曲面范围;
  26. The minimum breaking load of steel wire strands is investigated by experiments in this paper.
    通过大量的试验数据,对我国现在生产的钢绞线的最小断裂载荷进行讨论。
  27. A minimum load shedding method and a total transfer capability ( TTC) determining method are given based on Static Voltage Stability Region ( SVSR).
    重点研究了基于静态电压稳定域(SVSR)的最小切负荷算法和最大输电能力(TTC)快速计算方法。
  28. Secondly, load shedding is guided via the sensitivity information. The ones with higher sensitivity would have the higher priority to shed such that the minimum amount of load shedding can be ensured.
    切负荷的合理性:利用灵敏度指导切负荷,具有最大灵敏度的负荷被优先切除,保证了最少的切负荷量。